Control FX Tie Bar - Addco Type - Installation - 3rd Gen J's

Skill Level Step-By-Step Instructions
Easy
  1. Chock front wheels to prevent rolling, then raise the car securely to access the rear axle area.

  2. Remove the 1/2" bolt that secures the rubber bushing and the sway bar to the mounting plate. Figure #1

  3. Re-Insert existing bolt through the bracket. Figure#2

  4. Adjust the end links equally on both sides such that the overall length is equal to the distance between the attachment bolts. Slide the end links onto the new bolt and tighten. Figure#3

  5. Tighten the tie bar by hand by turning it counter-clockwise until it is snug.

  6. Snug the jam nuts on each end of the tie bar by hand, and then fully tighten them with your wrench so that the tie bar can no longer be turned by hand. Figure#4

Tools Required
  • Jack
  • Jack Stands
  • 1/2" Wrench
  • Ratchet
  • 1/2" Socket
  • Control FX Tie Bar
Credit
  • Vincent Keene

CLOSE WINDOW