| Easy |
Seat Back Removal/Reinstallation
- Remove Seat Belt from child adjustors, if applicable.
- Pull back of rear seat to a 45 degree angle. Seat will release
to the
right. All you have to do is push firmly to the right, while pulling
lower
left corner of off the rod sticking out, about 1.5".
Install in reverse order, right side rod first, then sliding over left
side rod.
Seat Bottom Removal
- 1. Hold seat bottom front on both sides, about
8-10" from sides.
- Lift seat. Pull forward.
Seat Bottom Reinstallation
- Look where seat bottom attached - there will be 2 holes in the floor.
It is likely that there will be a black clip
left in each of these holes.
Being VERY CAREFUL to note how they come
out, remove each clip, and
reattach to seat. It is easiest to do one at
a time, so if you drop the
clip, or whatever, it is easy to reorient
the clip based on the position of
the other one.
Clips, after being replace on seat bottom,
will need to POP back into
the holes. Place seat bottom in place,
pulling seat belts through the
slots. While pushing seat bottom back, push
the clips back into the hole.
Use some downward force to lock the clips
in place, and you are all done.
|