| Easy |
- Lower the back seat, and remove the 4 clips that hold the plastic
trim pieces to the rear dash.
- Next, remove the 2 plastic trim pieces. To do
this, pull them slightly toward you, and angle them toward the
ground. The small clips that hold them in will pop out of place.
- Pull the rear seat belts through the slots in the
back deck, and then pull the slots inward a bit. This will allow
the piece of rear deck that is under the sides to come free.
- Now just start pulling, and jiggling it a bit.
You may also need to bend the centre of the dash up slightly, being
careful not to crease it. It will eventually slide out.
- If you are trying to remove the rear speakers, simply
push in the little clips that are facing you. You will need to
disconnect the speaker wire connection. The factory speakers are
held in by 4 screws. Remove those and the factory speakers will
pop right out. The Rear Speakers Are 6X9's, but you can either
make or buy adapters so you can use a component speaker
system.
|