| Easy |
-
Move both seats to the furthest most rear position.
Remove seat belts from headrest loop, if applicable.
- Remove the rubber caps on top of the seat post bolts.
- Remove the front nuts using the 13mm socket and ratchet.
- Move seats to furthest most position. Remove rubber caps from seat
bolts.
- Remove the 2 bolts. You may need to use the 13mm wrench, as a
ratchet will not fit.
- [Driver's seat only] Before removing the seat, disconnect the seatbelt
sensor. Simply use a small screwdriver to pry up clip, and slide wire
out.
- Lift seat out, careful not to scratch paint.
- Reinstall in reverse order, remembering to use caution when setting
seats
in.
|