-
Roll the window down. This will
make replacing the door panel easier.
-
Remove the screw that holds the
triangle-shaped plastic piece over the mirror bolts.
-
Next, go down to the door handle grip,
and remove the 2 7mm screws out of there.
-
Go along the outside edge of the door
panel and remove all those screws.
-
If you have power locks, you will need to
disconnect the wires that run to the lock switch. Simply pop the
trim piece out that holds the power lock switch, and disconnect it.
-
If you have manual windows, you will need
to get the GM tool to remove the window cranks.
-
Now the only thing stopping you is the
clips that run along the top edge, by the window. Gently pull up,
and rock the entire door panel side to side.
-
When you are putting the door panels back
on, be sure to get all those little clips at the top of the door back on
and make sure they are tight, otherwise the door panel won't sit right.