Installing Clear Corner Lenses

1. Raise hood.

2. With a pair of pliers, remove the black fasteners securing the black radiator shield in the front. There should be 6 of them.  To remove them, take pliers and raise the head of the fastener, then pull the whole fastener assembly out.

3. Remove the black radiator shield.

4. Remove the 2 top bolts securing each head lamp assembly using a 13mm Socket.

5. Remove each head lamp gently without pulling too hard on the wires.  Tilting the headlamp assembly slightly forward and backward while lifting up is generally the best technique.  It is not necessary to remove the light bulb.

6. Reach down beside where the headlamp assembly once was, and remove the lamp socket from the turn signal housing using a counter-clockwise turning motion.

7. Remove the three 10mm bolts that secure the side signal light.

8. Remove signal light and install clear corner lights.  Change bulb if desired.

9. Reinstall head lamps and radiator shield.

• 13mm Socket
• 10mm Socket
• Needle-Nose Pliers or Flat Screwdriver

• Drew Taylor
• Ryan Currie

CLOSE WINDOW